Hughes HX200, Installation Manual

Page: 49 / 160

Chapter 3 • Commissioning the HX200 satellite router
1038054-0001 Revision B
39
If all cable connections are secure:
– Shut down and power off the satellite router.
– Shut down and power off the installer laptop.
– Turn the satellite router back on.
– Turn the installer laptop back on.
Also, make sure that neither an Ethernet router nor a switch is
currently connected to the satellite router, then try the ping test
again. If the test is still unsuccessful, contact Technical Support
for assistance.
Uploading the SBC
configuration file to the
HX200
The SBC configuration file (
sbc.cfg
) contains satellite
information that SBC and the auto-commissioning server (ACS)
must use during the commissioning process. Once you have
obtained the
sbc.cfg
file, save it on the installer laptop, making
sure to note the location in which the file is saved; then complete
the steps below.
1. Open a browser on the installer laptop.
2. Type
http://192.168.0.1/fs/registration/
setup.html
in the address bar and press E
NTER
. If an
alternate IP address was assigned to the satellite router at the
Note: If you do not have to upload an
sbc.cfg
file to the
satellite router, skip this section and go to Commissioning the
HX200 on page 41.