HP OmniBook 6000, Evaluation Manual

Page: 141 / 207

Using Windows NT 4.0
Using the Docking Solutions
Corporate Evaluator’s Guide 141
5. From the Control Panel, double-click SCSI Adapters, then click Drivers.
6. Click Add.
7. Click “Have Disk”.
8. Enter C:\TEMP\DOCKING\IDE\WINNT and click OK.
9. Click OK to accept the “CMD 64xx 32-Bit IDE Adapter”.
10. Enter C:\TEMP\DOCKING\IDE\WINNT and click Continue.
11. Click No when asked if you want to restart the system.
12. Click Add.
13. Click Have Disk.
14. Enter the C:\TEMP\DOCKING\SCSI\MINIPORT directory and click OK.
15. Click OK to accept the “Symbios Logic PCI (53c8XX)”.
16. Enter the C:\TEMP\DOCKING\SCSI\MINIPORT directory and click Continue.
17. Click Yes to restart the HP Notebook.
To configure a docked hardware profile
You can now dock the HP Notebook in the HP Notebook Docking System. When you
start Windows NT out of the HP Notebook Docking System you may receive errors
concerning these drivers. These errors will cease to occur when you create hardware
profiles and disable the appropriate docked hardware in the undocked profile.
To create Windows NT Hardware profiles, do the following:
1. Double-click the System icon in the Control Panel.
2. Click the “Hardware Profiles” tab.
3. Click the original configuration profile, then click Copy, and enter a name for your
docked configuration.
4. For each profile, click Properties on the Hardware Profiles tabs.
•
For the docked profile, click “This is a portable computer” on the “General” tab
and click “The computer is docked”. Click OK to close the profile properties
window.