HP OmniBook 6000, Evaluation Manual

Page: 134 / 207

Using Windows NT 4.0
Installing Windows NT 4.0
134 Corporate Evaluator’s Guide
If you are going to format as FAT enter 2048 or less.
If you are going to format as NTFS enter 4090 or less.
11. Select the C: partition and press Enter to install Windows NT.
12. Select the type of file system to install, then press Enter.
13. Press Enter to accept the default Windows NT directory or type in another directory.
14. Press Enter to allow Windows NT setup to examine your hard disk drive for
corruption.
15. When prompted, press Enter to reboot. (Do not remove the CD-ROM.)
16. Click Next to allow Setup to gather information about your computer.
17. Choose Typical from the Setup Options, then click Next. (If hard disk space is
limited, choosing Portable will install only the necessary components).
18. Enter your name and organization, then click Next.
19. Enter the 10-digit CD-key, then click Next.
The CD-key is located on the back of the CD jacket.
20. Enter a computer name, then click Next. This name is used by other computers on the
network to access your computer.
21. Enter an Administration password twice, then click Next. This password is used to
administer User IDs and Windows NT security.
22. Choose “No, do not create an emergency repair disk”, then click Next.
23. Choose “Install the most common components”, then click Next.
24. Click Next to Install Windows NT Networking.
25. Choose “Do not connect the computer to a network at this time”, then click Next.
26. Click Finish to finish setting up Windows NT.
27. Enter the correct Time Zone and Date and Time, then click Close.
28. Click OK twice to accept the VGA-Compatible Display Adapter (The video driver
will be installed in the next section.)
29. When prompted, click Restart Computer.