HP ML370 - ProLiant - G3, Reference And Troubleshooting Manual

Page: 273 / 317

Troubleshooting 273
Audible Beeps: None
Possible Cause: Hard drive X failed or cable is loose or defective. Following a
system restart, this message notes that drive X is defective and fault tolerance is
being used.
Action:
1. Be sure all cables are connected properly and securely.
2. Test and replace defective cables.
3. Replace drive X. (depending on the fault-tolerance level, all data may be lost
if another drive fails).
1788-Slot X Drive Array Reports Incorrect Drive Replacement...
...The following SCSI drive(s) should have been replaced: SCSI Port Y: SCSI ID Z.
The following SCSI drive(s) were incorrectly replaced: SCSI Port y: SCSI ID z.
Select F1 to continue – drive array will remain disabled.
Select F2 to reset configuration – all data will be lost.
Audible Beeps: None
Possible Cause:
•
•
•
•
Replacement drives may have been installed in the wrong drive bays.
A bad power cable connection to the drive, noise on the data cable, or
defective SCSI cable exists.
Action:
If replacement drives are installed in the wrong bays, properly reinstall the
drives as indicated and:
−
Press the F1 key to restart the server with the drive array disabled.
−
Press the F2 key to use the drives as configured and lose all the data on
them.
If a bad power cable connection exists: