HP ML370 - ProLiant - G3, Reference And Troubleshooting Manual

Page: 271 / 317

Troubleshooting 271
(5) Configuration information indicates drives were configured on a controller with a newer
firmware version.
Audible Beeps: None
Possible Cause: Drive array configuration not detected.
Action:
•
115 Run ACU ("Array Configuration Utility" on page ).
•
•
126
Power down the system and check SCSI cable connections to be sure the
drives are connected properly.
Run ADU ("Array Diagnostic Utility" on page ) if previous positions are
unknown. Then, turn the system power off and move the drives to their
original positions.
•
•
To avoid data loss, reconnect the drives to the original controller or upgrade
the controller firmware to the version on the original controller (or higher)
using Options ROMPaq.
1786-Slot 1 Drive Array Recovery Needed...
...The following SCSI drive(s) need Automatic Data Recovery: SCSI Port Y: SCSI ID Z
Select F1 to continue with recovery of data to drive. Select F2 to continue without recovery
of data to drive.
Audible Beeps: None
Possible Cause: A failed or replacement drive has not yet been rebuilt.
Action:
Perform one of the following actions:
−
Press the F1 key to continue with recovery of data to the drive. Data will
be automatically restored to drive X when a failed drive has been
replaced, or to the original drive if it is working again without errors.
−
Press the F2 key to continue without recovery of data to the drive. The
failed drive will not be rebuilt and the system will continue to operate in
a failed state of Interim Data Recovery Mode.