-64
Figure 44: Tip Shield installation
6. Exit
Maintenance
, press
Done
until back at
Idle
.
Remove debris from the Filament Present switch
There may be a time when the Filament Present switch needs to be cleared in
addition to the 500 hour maintenance. For example, if a
Material Error-
Filament blocked
message appears on the display panel; the
recommendation may be to clear debris from the Filament present switch.
1. Unload material from the printer and remove the material carriers.
2. Open the material bay doors by gently pressing in to release and pull-
ing outwards.
3. Remove the material carriers by first pushing them in to unlatch and then
pulling them outwards.
4. Disconnect the material tubes from the rear of the material bay(s). Leave
them attached to the Y block.
5. Locate the entrance hole to the Filament Present Switch in the material
bay(s). See
Summary of Contents for DESIGNJET 3D
