-319
Chamber Thermocouple
Required Tools
•
5
⁄
16
” nut driver.
• standard screwdriver.
Removing the chamber thermocouple
1. Remove the top panel. See
“Removing the top panel” on page 161
2. Remove the side panels. See
“Removing the side panels” on page 162
3. Remove the upper electronics bay cover. See
tronics bay cover” on page 173
4. Remove the electronics bay. See
“Removing the electronics bay” on
5. Push the strain relief clip out towards the front of the printer using a small
standard screwdriver. See
Figure 300: Strain relief clip location
6. Bend the tip of the thermocouple straight and slide out through the strain
relief clip.
7. Remove the thermocouple.
Installing the chamber thermocouple
1. Push the thermocouple through the mounting hole until it is 3/4” (19mm)
through the other side.
2. Push the strain relief in to lock the thermocouple in place.
3. Bend the thermocouple over to the left. See
Push the strain relief tab
towards the front of the
printer to remove.
Summary of Contents for DESIGNJET 3D
