HP DESIGNJET 3D, Service Manual

Page: 51 / 458

-35
Figure 22: Connecting the material bay cables
23. Connect the power cable, network cable and UPS cable if used.
24. Switch the circuit breaker to the ON position.
25. Power the printer ON at the power switch.
26. After the printer has booted up, you may need to reload the printer firm-
ware. If the printer displays “
Send Upgrade from Workstation
”, See
“Updating printer firmware:” on page 53.
27. Insert model and support material spools into the new material carriers.
28. From display panel press
Material
. Display will show
Add/Remove
.
29. Open material bay doors and push both red handled model carriers
into right side of the material bays until they latch.
30. Push both black handled support carriers into left side of the material
bays until they latch.
31. Press
Load Selected
. The printer will load the first material bay and pre-
pare the second material bay for automatic loading. When the printer
has finished loading material, S1 and M1 will be marked with asterisks.
All material bay LED’s will be solid.
32. When finished loading material press
Done.
Display will show
Idle
and
amount of material remaining for model and support in both material
bays.
NOTE: Material may take up to ten minutes to load.