HP DESIGNJET 3D, Service Manual

Page: 45 / 458

-29
(NM) address. Follow the same steps for setting the Netmask (NM) and
Gateway (GW) addresses.
9. When you have finished setting the addresses, press
Done
. The display
will show:
Change IP, Netmask and Gateway?
10. Press
Yes
. The panel then displays
Resetting Network
.
11. Press
Done
until
Idle
is displayed.
Establish communication:
1. From your workstation, start the HP Designjet 3D Software Solution.
A. From the
General
tab, click the
Manage 3D Printers
button.
B. Click the
Add from Network
button in the lower right corner
of the window.
C. A new window,
Add 3D Printer
, should list your printer
(identified by its UDN). Click on the printer in this window
and enter a name and location of your choice in the lower
portion of the window.
D. Click
Add Printer
to complete. Close the
Add 3D Printer
window.
2. If your printer is not displayed in the
Add 3D Printer
window, you will
need to add the printer IP address manually.
A. From the
General
tab, click the
Manage 3D Printers
button.
B. Click the
Add Manually
button in the lower right corner of
the window.
C. In the
Add 3D Printer
window, enter a name and location
of your choice in the appropriate fields.
D. Enter the IP Address for your printer in the appropriate field.
It will be the same address as entered in step 6.
E. Select your printer type from the drop down list, either HP
Designjet 3D or HP Designjet Color 3D.
F. Click
Add Printer
and close the
Add 3D Printer
window.
3. If you are unable to connect the printer to your workstation, contact your
Network Administrator.
NOTE: If you only have one printer connected, it will be the only
printer in the list.