HP DESIGNJET 3D, Service Manual

Page: 446 / 458

-430
Send Calibration
The Send Calibration button allows you to send the complete set of factory
calibrations to the printer as a single file. This includes but is not limited to:
Tip Offset, Tip Depth, YLash, X Correction, and the gantry DAT file. A
calibration file can be retrieved from the modeler using
Get Calibration
.
When this button is pressed a dialog box appears that allows you to browse
for and select the calibration file to send to the printer.
Get Configuration
Clicking the
Get Config
button will download the configuration file from the
printer.
Test Parts
Test Parts consists of downloading sample and test part files to the printer.
The files must be in the .cmb.gz format produced by HP Designjet 3D
Software Solution.
The Test Part dialog allows you to browse for and select the sample or test
file and to download it to the printer. The Test Parts are not preserved during
a software upgrade.
To remove unwanted test parts, upgrade the software to the current level and
only the factory test parts will remain on the system.
Reset Password
This button resets the administrator password to null. This turns off password
control of the queue. This is used for clearing a forgotten password.
Connect
If the system is not available over the network, when HP Designjet 3D
Diagnostic Software first loads, HP Designjet 3D Diagnostic Software will
only try to connect one time. This allows you to interact with HP Designjet 3D
Diagnostic Software when it is not connected to a printer. The Connect
button allows you to request additional connection attempts.