HP DESIGNJET 3D, Service Manual

Page: 436 / 458

-420
Hard Drive Installation Checklist
Replace the hard drive.
Verify that all cables are connected correctly.
Clean and vacuum the system.
Power system up.
After 10 minutes to 45 minutes, the LCD will display
UPGRADE
and
Send Upgrade From Work Station
along with the Dynamic IP Address
of the system (the default system setting).
• If the system will be operating in a Dynamic environment, the UPGRADE
can be loaded from the PC.
Use the Manage 3D Printers button in HP Designjet Software Solution to
connect to the printer -Choose
“Add from Network...”
• If the system will be operating in a Static environment, choose
Set Net-
work...
from the display panel and enter the appropriate network
addresses. The customer should provide this information.
After all the addresses have been edited, select
Done
.
Use the Manage 3D Printers button in HP Designjet Software Solution to
connect to the printer - Choose
“Add Manually...”
Download the printer firmware using the most current version. Download
instructions for performing the download procedure are located on the
firmware CD.
Once download is complete, system will reach “Idle”.
Load material.
Run a small test part to ensure part quality is acceptable and that the
system is operating properly.
NOTE: For convenience, the assigned IP address is visible in the
display panel during this process.
NOTE: The printer firmware must be downloaded before system
operation can continue.