Hospira LifeCare XL Series, Technical & Service Manual

Page: 72 / 278

6.2 ALARM MESSAGES AND ERROR CODES
Technical Service Manual 6 - 9 430-00587-008 (Rev. 2/05)
64-1 Input/output motor
phase loss Input/output motor does
not have enough torque Replace mechanism
assembly
(Section 7.2.9.2)
Mechanical breakage
in mechanism
65-1 Primary/secondary
motor phase loss Primary/secondary motor
does not have enough
torque Replace mechanism
assembly
(Section 7.2.9.2)
Mechanical breakage
in mechanism
71-1 Internal timers
out of tolerance Internal MCU PWA
malfunction Replace MCU PWA
(Section 7.2.9.1)
73-1 +2.5-VDC ADC
reference voltage out of
tolerance +2.5-VDC reference
to ADC missing or bad Check fuse F3 on power
supply PWA; replace
fuse, if defective
(Section 7.2.8.1)
If condition recurs,
contact Hospira
+3.75-VDC reference
to ADC missing or bad Check fuse F3 on power
supply PWA; replace
fuse, if defective
(Section 7.2.8.1)
If condition recurs,
contact Hospira
ADC failure Replace MCU PWA
(Section 7.2.9.1)
73-2 +5-VDC ADC reference
voltage out of tolerance +2.5-VDC reference
to ADC missing or bad Check fuse F3 on power
supply PWA; replace
fuse, if defective
(Section 7.2.8.1)
If condition recurs,
contact Hospira
+3.75-VDC reference
to ADC missing or bad Check fuse F3 on power
supply PWA; replace
fuse, if defective
(Section 7.2.8.1)
If condition recurs,
contact Hospira
ADC converter failure Replace MCU PWA
(Section 7.2.9.1)
74-1 Air sensor self test
failure; signal seen when
sensors disabled Air sensor or circuitry failure Replace mechanism
assembly
(Section 7.2.9.2)
74-4 Proximal air sensor
signal too high Air sensor or circuitry failure Replace mechanism
assembly
(Section 7.2.9.2)
74-5 Distal air sensor signal
too high Air sensor or circuitry failure Replace mechanism
assembly
(Section 7.2.9.2)
Table 6-2. Error Codes Requiring Technical Service
Error
Code
Malfunction
Description Possible Cause Corrective Action