Hospira LifeCare XL Series, Technical & Service Manual

Page: 71 / 278

SECTION 6 TROUBLESHOOTING
430-00587-008 (Rev. 2/05) 6 - 8 Plum XL Series
60-1 Plunger motor position
flag stuck high during
re-synchronization Position sensor failure Replace mechanism
assembly
(Section 7.2.9.2)
Plunger motor not moving Check connection
at J7 on MCU PWA
If condition recurs,
contact Hospira
60-2 Plunger motor position
signal is continuous
low during
re-synchronization Position sensor failure Replace mechanism
assembly
(Section 7.2.9.2)
Enable circuit failed Check connection
at J7 on MCU PWA
If condition recurs,
contact Hospira
Plunger motor not moving
61-1 Input/output motor
position flag is
continuous high during
re-synchronization Position sensor failure Replace mechanism
assembly
(Section 7.2.9.2)
Input/output motor
not moving Check connection
at J8 on MCU PWA
If condition recurs,
contact Hospira
61-2 Input/output motor
position signal is
continuous low during
re-synchronization Position sensor failure Replace mechanism
assembly
(Section 7.2.9.2)
Enable circuit failure Check connection
at J8 on MCU PWA
If condition recurs,
contact Hospira
Input/output motor
not moving
62-1 Primary/secondary
motor position flag is
continuous high during
re-synchronization Position sensor failure Replace mechanism
assembly
(Section 7.2.9.2)
Primary/secondary
motor not moving Check connection
at J9 on MCU PWA
If condition recurs,
contact Hospira
62-2 Primary/secondary
motor position signal is
continuous low during
re-synchronization Position sensor failure Replace mechanism
assembly
(Section 7.2.9.2)
Enable circuit failure Check connection
at J9 on MCU PWA
If condition recurs,
contact Hospira
Primary/secondary
motor not moving
63-1 Plunger motor phase loss Plunger motor does not
have enough torque Replace mechanism
assembly
(Section 7.2.9.2)
Mechanical assembly
failure
Table 6-2. Error Codes Requiring Technical Service
Error
Code
Malfunction
Description Possible Cause Corrective Action