Hospira LifeCare XL Series, Technical & Service Manual

Page: 66 / 278

6.2 ALARM MESSAGES AND ERROR CODES
Technical Service Manual 6 - 3 430-00587-008 (Rev. 2/05)
08-1 AIR IN LINE
BACKPRIMING
Empty
container
alarm 500 µL of air
detected entering
the cassette in
the last two intake
strokes Change
container
and backprime
to expel air
10-1 CHECK SETTINGS
mL/H=mL?
Check
settings
alarm Rate and VTBI
settings not
correct Turn control
knob to
SET RATE
or SET VTBI
to check settings
or enter values
11-1 TURN TO RUN Turn to run alarm Rotary control
knob not in
OFF/CHARGE
or RUN position,
or no key is
pressed for
five minutes Turn control
knob to RUN,
OFF/CHARGE,
or HOLD/RESET
12-1 VTBI COMPLETE
mL=mL
Primary VTBI
complete alarm The VTBI for
the primary
channel has
been delivered Discontinue
infusion,
or change
container and
program new
VTBI setting
12-2 Secondary VTBI
complete alarm The VTBI for
the secondary
channel has
been delivered
13-1 CASSETTE
DOOR/CASSETTE
(XL only)
or
Input/output
valve leak
test failure Defective
administration set
Cassette
improperly
loaded or
improperly
primed
Turn control
knob to
OFF/CHARGE,
open and close
cassette door,
then restart
If condition
recurs, replace
administration
set
Turn control
knob to OFF/
CHARGE or
HOLD/RESET,
reprime cassette
and restart
13-2 Primary/
secondary
valve leak
test failure
13-3 Valve leak
test failure
due to excessive
signal noise Fluid spillage
around valve pins Clean valve pins
Table 6-1. Operational Alarm Messages and Corrective Actions
Error
Code
Alarm Message Description Possible Cause
Corrective
Action