Honda CB HORNET 160R 2015, Shop Manual

Page: 77 / 336

5-5
FUEL SYSTEM
Clamp the hose to the frame carefully and connect the air
vent hose to the carburetor (page 5-16).
Carefully route the wire from the clamp on the air cleaner
housing and connect the rear brake light switch 2P
connector.
Install the following:
– Air cleaner element (page 3-6)
–
Fuel tank (page 2-4)
– Left side cover (page 2-3)
– Right side cover (page 2-3)
While installing
the drain hose
route the
wire harness
properly
page (1-18)
BREATHER HOSE
AIR VENT HOSE
CLAMP
RR BRAKE LIGHT
SWITCH
STARTING ENRICHMENT (SE) VALVE
REMOVAL/INSTALLATION
Remove the fuel tank right cover. (page 2-4).
Loosen the air cleaner connecting boot band screw and
insulator band screw from carburetor.
Loosen the starting enrichment (SE) valve lock nut and
remove the SE valve from the carburetor body.
Check the SE valve for scoring , scratches or wear.
Check the seat at the tip of the SE valve for stepped wear.
Replace the SE valve set if necessary.
When installing new SE valve, compress the spring and
release the choke cable and spring from the SE valve.
Install the SE valve to the choke cable.
SE VALVE
SE VALVE
CHOKE CABLE
SPRING
BAND SCREW
CARBURETOR
SE VALVE LOCK
NUT/ SE VALVE
INSULATOR
SCREW