Honda CB HORNET 160R 2015, Shop Manual

Page: 78 / 336

5-6
FUEL SYSTEM
BAND SCREW
CARBURETOR SE VALVE LOCK
NUT/ SE VALVE
INSULATOR
SCREW
Install the SE valve to the carburetor body.
Tighten the SE valve lock nut.
TORQUE: 2.3 N·m (0.2 kgf·m, 1.7 lbf·ft)
After the installation, check for the smooth operation of
the choke lever.
Install the fuel tank (page 2-4).
Install the left side cover (page 2-3)
Handle the SE
valve lock nut
with care that
can easily be
damaged.
CARBURETOR
REMOVAL
Remove the fuel tank right side cover (Page 2-4).
Loosen the insulator band screw and air cleaner connecting
boot band screw.
Disconnect the SE valve (page 5-5).
Disconnect the air vent hose and the throttle sensor
3P connector (page 16-7).
Turn the fuel valve “OFF”, and disconnect the fuel hose
from the carburetor.
DRAIN SCREW
DRAIN HOSE
Loosen the drain screw and drain the fuel from the float
chamber into the approved gasoline container.
Completely drain any residual fuel, tighten the drain screw
to the specified torque.
TORQUE: 1.5 N·m (0.2 kgf·m, 1.1 lbf·ft)
Disconnect the drain hose from the carburetor.
Loosen the throttle cable lock nut and disconnect the
throttle cable end from the throttle drum.
THROTTLE DRUM
CABLE END
LOCK NUT
7-9 mm
(0.3-0.04 in)
30 0
INSULATOR
SCREW
BAND
SCREW
AIR VENT
HOSE
CARBURETOR
THROTTLE SENSOR
3P CONNECTOR
SE VALVE LOCK
NUT/ SE VALVE
7-9 mm
(0.3-.04 in)
30
0