Honda CB HORNET 160R 2015, Shop Manual

Page: 50 / 336

3-12
MAINTENANCE
ENGINE OIL STRAINER SCREEN
REMOVAL/INSTALLATION
Remove the right crankcase cover (page 9-3).
Pull the oil strainer screen out of the crankcase.
Wash the oil strainer screen thoroughly in nonflammable
or high flash point solvent until all accumulated dirt has
been removed.
Blow dry it with compressed air to clean completely. Before
installing the strainer, it should be examined closely for
damage, and make sure the sealing rubber is in good
condition.
Install the oil strainer screen with the thin edge facing in
and flange side facing up as shown.
Install the right crankcase cover (page 9-5)
ENGINE OIL CENTRIFUGAL FILTER
Remove the right crankcase cover (page 9-3).
Remove the screws (3 Nos.) of oil filter by using gear holder
between clutch gear and Gear Primary Drive. Also remove
oil filter rotor cap and gasket.
TOOL: Gear Holder 07006–KRBT900
Be careful not to
damage the Oil
strainer screen.
Clean the oil filter rotor cover and inside of the oil filter rotor
using a clean shop towel.
Do not allow
dust and dirt
to enter the
oil passage in
the crankshaft.
Never use
compressed air
for cleaning.
OIL STRAINER SCREEN
OIL FILTER ROTOR
OIL FILTER ROTOR CAP
SCREWS
CLUTCH GEAR
GEAR
HOLDER
GEAR PRIMARY DRIVE
CRANKCASE
TICK EDGE
THIN EDGE
FLANGE SIDE