Honda CB HORNET 160R 2015, Shop Manual

Page: 281 / 336

15-3
BATTERY/CHARGING SYSTEM
BATTERY
VOLTAGE INSPECTION
Remove the left side cover (page 2-3).
Measure the battery voltage using a commercially available
FBT 50
battery tester.
VOLTAGE (20°C/68°F):
Fully charged: More than 12.4 V
Under charged: Below 12.4 V
If the battery voltage is below 12.4 V, charge the battery.
REMOVAL/INSTALLATION
Remove the left side cover (page 2-3).
Disconnect the negative (–) cable by removing the bolt.
Disconnect the positive (+) cable by removing the bolt.
Remove the bolt and open the battery band.
Remove the battery.
Install the battery in the reverse order of removal.
Connect the positive (+) cable first and then the
negative (–) cable.
Connect the tester probes to the battery terminal.
Always connect red probe to positive and black probe to
negative terminal.
BATTERY TESTING PROCEDURE
Check the battery pin number on front of the battery suface
and refer the table given below.
BATTERY BAND
BATTERY BAND
BLACK
PROBE
RED PROBE
S.No. Battery PIN No. Ref. No.
1
ETZ 3 3
2 ETZ 4 4
3
ETZ 5
33
4
ETZ 7 5
NEGATIVE
(-) CABLE
NEGATIVE
(-) CABLE
POSITIVE
(+) CABLE
POSITIVE
(+) CABLE
BATTERY
BATTERY
STAY
STAY
BOLT
BOLT
Always turn the
ignition switch
OFF before
removing the
battery