Honda CB HORNET 160R 2015, Shop Manual

Page: 32 / 336

2-4
FRAME/BODY PANELS/EXHAUST SYSTEM
FUEL TANK
Remove the fuel tank mounting bolts/washers (2 nos.).
While raising the fuel tank disconnect the fuel unit
3P (White) connector.
Disconnect the breather pipe, fuel tube and canister hose
pipe from the fuel tank
Pull back and remove the fuel tank.
Installation of fuel tank is in the reverse order of removal.
Install the fuel tank left & right side cover.
Install the fuel tank center cover.
Wipe the spilled
gasoline off at
once.
After installation,
turn the fuel
valve “ON”, and
make sure
that there are
no fuel leaks.
FUEL TANK
BOLT
WASHER
3P (WHITE)
CONNECTOR
BREATHER PIPE CANISTER HOSE PIPE
FUEL TANK CENTER COVER
Remove the following :
–
Socket bolt (3 nos.)from fuel tank cap
–
Screw (1 nos.) from fuel tank center cover rear side
–
Trim clip (2 nos.) from fuel tank center cover front side
Unlock the fuel tank cap by using ignition key and remove
the fuel filler cap.
Press the fuel tank side cover inwards and release the fuel
center cover first from rear side and then from front side.
Installation of fuel tank center cover is in the reverse order
of removal.
After removing
fuel filler cap
cover the fuel
tank opening
with masking
tape.
FUEL TANK LEFT & RIGHT SIDE COVER
Remove the following :
–
Fuel tank center cover
–
Screws (4 nos. each) from both side covers
Disengage the rear garnish hook from fuel tank side covers.
Carefully liftup the side covers upwards and release from
fuel tank mountings.
Installation of fuel tank left & right side cover is in the
reverse order of removal.