Honda CB HORNET 160R 2015, Shop Manual

Page: 294 / 336

16-6
IGNITION SYSTEM
TIMING HOLE CAP
RUBBER
BRACKET
6P CONNECTOR
4P CONNECTOR
CDI
Coat a new O-ring with engine oil and install it onto the
timing hole cap.
Install and tighten the timing hole cap to the specified
torque.
TORQUE:10 N·m (1.0 kgf·m, 7 lbf·ft)
IGNITION COIL
REMOVAL/INSTALLATION
Remove the right side cover (page 2-3).
Disconnect the spark plug cap from the spark plug.
Disconnect the wire connector from the ignition coil.
Remove the bolts and ignition coil.
Installation is in the reverse order of removal.
CDI (CAPACITIVE DISCHARGE IGNITION)
SYSTEM INSPECTION
Remove the fuel tank. (page 2-3).
Disconnect the CDI 6P White connector.
Turn the ignition switch “ON”.
Check the following at the wire harness side connector:
Item Terminal
Specification
Battery
line Red/Black (+) and
body ground (-) Battery voltage
should register
Ground
line Green and body
ground Continuity
should exist
REMOVAL/INSTALLATION
Remove the fuel tank (page 2-3).
Disconnect the CDI 4P and 6P White connector.
Remove the CDI from the rubber bracket.
Installation is in the reverse order of removal.
IGNITION COIL
BOLTS
CDI 6P CONNECTOR
WIRE CONNECTOR
CRANCKCASE CAP
O-RING