Honda CB HORNET 160R 2015, Shop Manual

Page: 233 / 336

13-9
REAR WHEEL/SUSPENSION
DRUM TYPE
Install the brake panel assembly from the right side of
wheel hub.
Install the driven flange assembly (page 13-11).
Slide the rear wheel such that the slot given on panel could
align with the protrusion given on swingarm and install the
drive chain.
Do not apply
grease on the
brake drum and
shoe linings
BRAKE PANEL
SLOT
PROTRUSION
JOINT PIECE
ROD SPRING
AXLE NUT
ADJUSTING NUT
RIGHT ADJUSTING PLATE
Hold the wheel up and Install rear Axle shaft from left
hand side. Install Adjusting Plates and screw axle nut to
specified torque.
TORQUE: 88 N.m (8.97 kgf.m, 64.9 Ibf. ft)
Install rod spring and after pushing down the brake pedal
connect the brake rod by inserting it into the Joint Piece.
Tighten the adjusting nut at the end of the rod.
Adjust brake free play (page 3-22).
Install drive chain (page 3-18).
AXLE NUT
AXLE SHAFT
RIGHT ADJUSTING
PLATE
DRIVEN FLANGE
REMOVAL
Remove the rear wheel (page 13-4).
DISASSEMBLY/INSPECTION
DRIVEN SPROCKET
Remove the side collar and dust seal.
SIDE COLLAR
DUST SEAL