NetWave DirectView Broadcast Console Operations & Technical Manual
Revision A
3 - Operation
Harris Broadcast
3-16
PR&E
Figure 3-13. Telco Record Output – Auto Foldback On
Auto Foldback On:
The record mix source follows the on/off state of all of the Telco channels. When all Telco channels are on,
Program 1 is the primary record mix. (If it is not assigned, Program 2, Program 3, Program 4 or Offline
is used in that order). When all Telco channels are off, Offline is the record mix source.
Note: Offline feeds are always pre-switch. They are normally set as pre-fader but may be changed during
console setup to be post-fader.
Link Plus Activation
When the console is linked to a VistaMax system using Link Plus, up to six channel sources can be set as
Telco channels. Each Telco has its own mix-minus and subsequently can be individually talked to using the
channel’s On or Off buttons.
Because the console only has two local mix-minus outputs, the four additional mix-minus outputs are routed
signals that go through the VistaMax system. To a board operator, this is not an issue since this routing is
done transparently and follows the same rules as outlined previously (mix-minus routing is performed
automatically following the bus assignments and whether Auto Foldback is on or off).
Having six Telcos in the console complicates how the Telco record bus output is used, especially if Auto
Foldback is active, since all Telco channels must be On to use a Program bus as the Telco Record source.
