NetWave DirectView Broadcast Console Operations & Technical Manual
Revision A
3 - Operation
Harris Broadcast
3-9
PR&E
Figure 3-8. Right Column -
Monitor Control Panel
Monitor Control Panel – Right Column Controls
Figure 3-8 shows the right column controls on a Monitor Control Panel.
Studio Monitor Source
All control room outputs use the same selected monitor source, which is indicated by the lit
button. Only one button can be selected at a time.
PGM 1-4 — When lit, routes the selected Program bus to the studio outputs.
EXT 1, EXT 2 — When lit, routes the selected External signal to the studio outputs.
Displays
VISTAMAX LINKED — When lit, indicates the console is properly connected and
communicating with a VistaMax Audio Management System. When not lit, the console is not
connected to a VistaMax system and has no networking capability.
STUDIO MUTE — When lit, indicates the room monitor output and studio warning logic are
active due to one or more channels, that have a studio mic as their input, being turned on and
assigned to a program bus. When not lit, no studio mic is turned on.
Studio Controls
MONITOR — Adjusts the output level of the studio monitor (ST MON) output.
TALKBACK — Adjusts the amount of talkback to the studio that feeds the studio monitor
output. Set the talkback control to full off if talkback should not feed the studio speakers.
TALK TO STUDIO — While pressed, routes the control room talk mics, pre-switch and pre-
fader, to the studio host output and to the room monitor output through the TALKBACK
control. Talk mics are inputs defined as CR MIC TLK SRC (control room mic talk source) and
are active. (That is, if the talk mic is the B input, the B source has to be selected on the
channel. If the A source is active, that mic’s audio does not feed the talk output.)
Event Timer Controls
AUTO RESET — When lit, allows the event timer to be reset when a channel that has timer
reset enabled is turned on. This resets the timer to 00:00.0 and starts counting upward. When
not lit, the event timer does not receive reset commands from the channels.
RESET — Resets the event timer to 00:00.0 and starts counting up. Press Reset and Stop
together to reset and stop the timer at 00:00.0.
HOLD — Press and hold the button to freeze the event timer display and show the elapsed
run time when the button was pressed. The event timer continues to count during this time.
Release the button to return the event timer display to show the current run time.
START — Starts the event timer counting up from the displayed time.
STOP — Stops the event timer and displays the elapsed time. Press START to continue
counting up from the displayed time. Press Reset and Stop together to reset the timer to
00:00.0.
