HappyJapan HCU2, Instruction Book

Page: 86 / 393

-CU -81
7-A
CAP FRAME
7-A TB01
7. Remove the cap holder frame from the cap
stretcher.
8. As shown in Fig. 5, install the cap frame on
cap in the drive frame.
Rotate the cap frame as show in the Fig 5
so that the brim of the cap cannot hit the
machine. Then, push the holder lever in the
3 places shown in the arrow in Fig. 5, and
install the cap frame in the cap drive frame
so that so that the center guide of the drive
frame fits the concave area of the cap frame.
Confirm that the cap frame is firmly installed on
the cap drive frame without any gap.
If there is a gap between the cap frame and the
cap frame drive or the holder lever does not fit the
hole of the cap frame, adjust loosen the set screw
on the hold lever to adjust the position.
Clip Clip Lever for clip
6. As shown in Fig. 4, tip the cap
stretcher forward.
Clip the back of the cap and
nonwoven fabric in two places.
Make the clip livers face each other.
Fig. 4
Fig. 5
Hold
lever
Cap drive
frame
Center
guide