HappyJapan HCU2, Instruction Book

Page: 7 / 393

-CU -6
SETTING UP THE MACHINE
for quali fi ed personnel only
2_1 V624
2-1
Assemble machine unit
1. Insert thread stand felt on the thread stand.
2. Turn the thread guide pillar clockwise with a
3 mm hexagonal driver until tight.
3. Install the thread guide bracket with supplied
screws (pan head screw M4 X 8 2 pcs).
4. Remove the screw with the included o
ff
set
driver and remove the red stoppers on the
left and right back of the moving head.
(Keep the stoppers. It is necessary when
packing.)
5. Loosen the fi xing screws (2 upper and
lower) of the arm with the o
ff
set driver,
slowly raise the control box to the front and
fi x the screws.
6. Install the tubular frame arm for embroidery.
Please refer to (page 6-1) “Installing and
removing the tubular frame arm”.
Or, Install the cap frame for the cap
embroidery. Please refer to (page 7-1)
“Installing and removing the cap drive
frame”.
7. Insert built-in stylus into the holder (slot) of
control box.
When taking the machine apart in case
of packing, the process is opposite of
assembling the machine. Please do exactly
the opposite way of assembling.
When packing the machine up for
transportation, be sure to select the eighth
needle and fi x it with stoppers on the both
side of the guide bar.
Thread guide pillar
2-1
Thread stand
felt
Thread guide Screws
Screws (upper and lower)
Screw Stylus
Stopper