HappyJapan HCU2, Instruction Book

Page: 280 / 393

-U2 -187
24-3
ERRORS AND WHAT TO DO
24_3 W831
No. Display Error Solutions Page
090 Miss reception Error has occurred during data transfer
(via cable) between machine and PC.
Try reading pattern data again. Verify
that transmission speed setting is correct
at (1) transfer software; (2) device
manager of PC and (3) RS-232C speed
of machine.
5-4
091 No send Machine has not received data for > 10
seconds during data transfer.
5-4
103 Tape format Machine unable to determine format of
pattern data.
Verify format of pattern data and fi x if
necessary.
5-6
10-3
104 Miss function Timing to read pattern data does not
conform.
Read pattern data again from the start. 5-4
105 Dual function Data has been detected in the pattern
that has ambiguous/dual function.
Read pattern data again from the start. 5-4
106 No function Interval between start read time and
time of reception of actual pattern data
is too grea.
Check quality of design data.
108 Improper read While reading pattern data, error has
occurred in internal processing.
Read pattern data again from the start. 5-4
110 Memory full Memory has fi lled while reading in a
design.
Delete unnecessary patterns from
machine memory and try again.
5-B
111 Change over While reading pattern data, # of color
changes (color No.) has exceeded 250. Divide pattern data such that number of
color changes of each segment is less
than 250.
112 Data error Pattern data of current design is
damaged. Delete pattern and re-load. 5-B
114 Id over # of patterns in control panel memory
has exceeded the maximum of 3,000. Delete unnecessary patterns from
machine memory and try again. 5-B
116 Not found Id Speci fi ed pattern does not exist. Check setting.
118 Trace data over Over 1024 stitches trace data were
created during reading of pattern data.
Set maximum stitch length to embroidery
area of pattern data within 2m
(lengthwise) x 2m (sideways).
120 Memory error Fault in retaining contents of pattern
memory. If this occurs frequently, it is likely that
LCD-T board is faulty.
Contact your Dealer.
130 Disk error Unable to communicate continuously
with memory media. Power down machine and after a 10
seconds, power on again.
If error remains, contact your Dealer.
131 Device no ready Memory media is not set. Check if memory media is properly set. 5-5
133 Bad disk Improper or faulty memory media. Memory media that media reading unit
can't read or faulty media or un-initialized
media. 5-5
141 Not found name Designated pattern is not found. Memory card is not correct. 5-5
142 Disk full Memory media is full to capacity. Clear unnecessary patterns or use a
di
ff
erent memory media.
143 Multi name Another pattern with same name has
been detected while attempting to write
to memory media. Change name, use a di
ff
erent memory
media, or overwrite existing pattern.
190 Cut blade Thread cut knife is not at stop position. Follow the instructions below. 24-6
191 Cut sensor Thread cut knife is not at stop position. Check if threads are jammed around the
thread cutting knife.
Press the thread cutting button 2~3 times.
If error remains, contact your Dealer. 23-2
23-3