GRASS VALLEY JUPITER -, Installation And Operating Manual

Page: 296 / 310

296 JUPITER CM-4400 Control Module Installation and Operating Manual
Appendix B — Connecting Legacy and 3rd Party Routers
Pro-Bel SW-P-08 Protocol
The 7.9 version of the Jupiter system supports two new protocol drivers, for
AccuSwitch, that implement parts of the Pro-Bel SW-P-08 protocol. The
first driver is implemented as a standard Remote Router control interface.
The second driver is implemented as an Automation, or a Control panel,
interface.
Figure 233. Pro-Bel SW-P-08 Router Switcher Setup
This section will describe the needed setup and configuration steps to use
the Pro-Bel SWP-08 protocol for:
• Jupiter Router control
• Remote Router control
Jupiter Router Control
You will need to configure the Jupiter CM-4400 to use a Pro-Bel SW-P-08
Router Control port. This is accomplished by adding entries in the Serial
Protocol and MPK Devices tables.
Note These steps assume that the CM-4400 has been configured properly.
Entering Serial Protocol Information
You may need to modify the Configuration set that is currently active; if so,
Grass Valley recommends that you make a copy for editing before making
these changes.
For more information about modifying the Configuration set, please see
Modifying and Downloading a System Configuration Set on page 129 .
Note On the Title bar of the Jupiter Configurator application you will see the name
of the Configuration set. Make sure that the configuration set that is opened
is the correct set that you want to change.
CM-4400
P8R or P08 protocol
“Hi speed serial” port
or
“Port 4”
Pro-Bel router
Any available serial port