GRASS VALLEY JUPITER -, Installation And Operating Manual

Page: 200 / 310

200 JUPITER CM-4400 Control Module Installation and Operating Manual
Section 5 — The Configurator Application
The Non-Sequential Path Finding Table
The Non-Sequential Path Finding table must be used if the tie lines joining
the switchers are not wired sequentially, that is, not wired as blocks. Basi-
cally, the table is designed to enter “exceptions” to the Sequential table. For
example, a new tie line that falls outside the original sequence can be
defined on the Non-sequential table; the only change then needed on the
Sequential table would be to increment the “Count” number for the group
by 1. (Alternatively, you may prefer to use the Non-sequential table to
define all tie lines individually.)
Figure 147. The Non-Sequential Path Finding Table
An example system is shown in Figure 148 on page 201 , with corre-
sponding tables shown in Figure 149 on page 202 . Notice that the Path
Finding Data table, and the Switcher Input tables, must still be used as
described in the previous section.
1
Non−Sequential Path Finding
Path Finding
GROUP1
Line
3
Physical
83
Physical
87
2 GROUP1 4 84 88
3 GROUP2 3 83 87
4 GROUP2 4 84 88
5 GROUP3 3 83 87
6 GROUP3 4 84 88
7 GROUP4 3 83 87
8 GROUP4 4 84 88
9 GROUP5 2 82 20
10 GROUP6 2 82 20
11 GROUP7 2 82 20
12 GROUP8 2 82 20
Number Output Input
Group Name
071876600_nonseqpathfind