Gestetner G060, Service Manual

Page: 929 / 1106

FIRMWARE HISTORY
SM 14-3 G060
Firmw
are
Histo
ry
DESCRIPTION OF MODIFICATION
FIRMWARE
LEVEL
SERIAL
NUMBER
FIRMWARE
VERSION
Continued From Pervious Page
!
The New Coverage Counters will only
display the value of 999.99 and will not
function. The Coverage Counter
[7-833-05 to 08] provides image coverage
calculations for when Meter Charge Mode
(SP9-930 set to 0) is set to
“OFF.” Use the
Coverage Counter [SP7-833-05 to 08] if
Meter Charge Mode (SP9-930 set to 0) is
set to
“OFF.” Use the New Coverage
Counter [SP7-908-01 to 08] when Meter
Charge Mode (SP9-930 set to 1) is set to
“ON.” SP7-908-5 to 8 displays the same
data as SP7-833-11 to -14.
!
The machine automatically detects
whether a 4kB or 8kB NVRAM is installed
on the BCU board.
!
A grid pattern has been added to SP mode
copy images. To activate this, it is
necessary to use system firmware ver1.07
or newer (for the CF expander only).
The following have been corrected:
!
SC240 misdetection.
!
When the K toner cartridge is replaced, the
“previous PM counter” values for CMY are
all overwritten to the previous value for K
toner (SP7-906-23 to –25).
!
If machine enters Energy Saver 1 Mode
then cools down for more than 1 minute, it
will not display “Ready” after recovery
warm-up (only for G060-17 models).
!
When a B/W job is performed, the
coverage counters (SP7-833-1 to -4) for
CMY are not set to 0 as they should be, i.e.
the values from the previous job remain.
G0775623 March
2002
(See Note 2)
B1.17C
The following have been corrected:
!
Main scan magnification error
!
SC471 caused by stop timing error for
transfer belt contact motor.
!
SC545 in fusing phase control mode.
!
SC543
NOTE: This version has not been released
(see
“side effect” in Version B1.18B).
G0775623 A May 2002 B1.18
Rev. 10/2002