Gestetner G060, Service Manual

Page: 928 / 1106

FIRMWARE HISTORY
G060 14-2 SM
DESCRIPTION OF MODIFICATION
FIRMWARE
LEVEL
SERIAL
NUMBER
FIRMWARE
VERSION
G0775621 A December
2001
B1.15E
!
Fusing clutch control has been added to
start/stop the clutch.
The following has been corrected:
!
When a paper jam occurs midway through a
staple job, job recovery may re-start the job
from the 1st page instead.
!
Over-occurrence of the following SC codes
(due to software bugs) has been fixed:
!
SC220/230 at the start of a job.
!
SC544/554 during warm-up under low-temp
conditions in 62.5mm/sec mode.
!
SP1-916 (Idling mode) has been added.
G0775623 March
2002
(See Note 2)
B1.17C
!
To optimize the amount of oil supplied to the
fusing belt in OHP mode, the number of
supply cycles during idling has been
reduced to 1.
!
SP1-996-6 (OHP Pre-Job mode) has been
added.
Continued Next Page
[Idling Mode]
1 Mode Set Enables or disables fusing unit idling performed after the machine
reaches the Ready condition. Idling is performed for the time
specified in SP1-916-2.
[0 or 1/ 0 / -]
DFU
0: OFF, 1: ON
2 Idling Time Specifies the time for fusing unit idling.
[10 to 120 / 30 / 10 sec/step]
DFU
916
3 Pre-Job Mode
*
Enables or disables the 4-second fusing unit idling performed at
the start of a print job.
[0 or 1/ 0 / -]
DFU
0: OFF, 1: ON
[OHP/TH Fusing] 996
6 Pre-Job Mode * Enables or disables the 30-second fusing unit idling performed at
the start of an OHP print job. When enabled, idling is performed
even if the machine is at the Ready condition.
[0 or 1/ 0 / -]
0: OFF, 1: ON
NOTE 2 – Engine main firmware version B1.17C was applied to the production line on February
18th, 2002, and most machines with Ver. B1.15E have been reworked locally: However, some of
these machines have been released to the market without modification. Therefore please update
the engine firmware to ver B1.17C or newer on G060-17 machines in the following serial number
range: P60112xxxxx – P60201xxxxx.
Rev. 10/2002