Gestetner G060, Service Manual

Page: 1080 / 1106

Firmware History for G060
Page 3 of 16
DESCRIPTION OF MODIFICATION
FIRMWARE
LEVEL
SERIAL
NUMBER
FIRMWARE
VERSION
CHECK
SUM
G0775621 A December
2001
B1.15E 171C Fusing clutch control has been added to
start/stop the clutch.
The following has been corrected:
When a paper jam occurs midway through a
staple job, job recovery may re-start the job
from the 1st page instead.
Over-occurrence of the following SC codes
(due to software bugs) has been fixed:
SC220/230 at the start of a job.
SC544/554 during warm-up under low-temp
conditions in 62.5mm/sec mode.
SP1-916 (Idling mode) has been added.
G0775623 March
2002
(See Note
2)
B1.17C 169B To optimize the amount of oil supplied to the
fusing belt in OHP mode, the number of
supply cycles during idling has been
reduced to 1.
SP1-996-6 (OHP Pre-Job mode) has been
added.
Continued Next Page
[Idling Mode]
1 Mode Set Enables or disables fusing unit idling performed after the machine
reaches the Ready condition. Idling is performed for the time
specified in SP1-916-2.
[0 or 1/ 0 / -]
DFU
0: OFF, 1: ON
2 Idling Time Specifies the time for fusing unit idling.
[10 to 120 / 30 / 10 sec/step]
DFU
916
3 Pre-Job Mode
*
Enables or disables the 4-second fusing unit idling performed at
the start of a print job.
[0 or 1/ 0 / -]
DFU
0: OFF, 1: ON
NOTE 2 – Engine main firmware version B1.17C was applied to the production line on February
18th, 2002, and most machines with Ver. B1.15E have been reworked locally: However, some of
these machines have been released to the market without modification. Therefore please update
the engine firmware to ver B1.17C or newer on G060-17 machines in the following serial number
range: P60112xxxxx – P60201xxxxx.
[OHP/TH Fusing]
996
6 Pre-Job Mode * Enables or disables the 30-second fusing unit idling performed at
the start of an OHP print job. When enabled, idling is performed
even if the machine is at the Ready condition.
[0 or 1/ 0 / -]
0: OFF, 1: ON