Gestetner G060, Service Manual

Page: 741 / 1106

F
ax Un
it
G
307
BIT SWITCHES
SM 3-17 G307
System Switch 11 SP No. 1-101-018
No FUNCTION COMMENTS
4 Type of TTI used for
transmission using the ten-key
pad
0: TTI_1
1: TTI_2 1: The machine uses TTI_2 when the user dials the
destination using the ten-key pad. It is also used
for polling transmission and manual transmission
using the handset.
5-6 Not used Do not change the factory settings.
7
Use of parallel memory
transmission with G4
transmission
0: Disabled 1: Enabled This determines whether parallel transmission can
be used with a G4 transmission or not.
Note that this bit is only effective if Parallel Memory
transmission is enabled (User Parameter 07 - bit 2).
System Switch 12 SP No. 1-101-019
No FUNCTION COMMENTS
0
to
7
TTI/CIL printing position in the
main scan direction TTI/CIL: 08 to 92 (BCD) mm
Input even numbers only.
This setting determines the print start position for
the TTI and CIL from the left edge of the paper. If
the TTI is moved too far to the right, it may overwrite
the file number which is on the top right of the page.
On an A4 page, if the CIL is moved over by more
than 50 mm, it may overwrite the page number.
System Switch 13 - Not used (do not change the settings)
System Switch 14 - Not used (do not change the settings)
System Switch 15 SP No. 1-101-022
No FUNCTION COMMENTS
0 Not used Do not change the settings.
1
Going into the Energy Saver
mode automatically
0: Enabled
1: Disabled
1: The machine will restart from the Energy Saver
mode quickly, because the +5V power supply is
active even in the Energy Saver mode.
2-3 Not used Do not change the settings.
4-5
Interval for preventing the
machine from entering Energy
Saver mode if there is a
pending transmission file.
Bit 5 4
Setting
0 0 1 min
0 1 30 min
1 0 1 hour
1 1 24 hours
If there is a file waiting for transmission, the machine
does not go to Energy Saver mode during the
selected period.
After transmitting the file, if there is no file waiting for
transmission, the machine goes to the Energy Saver
mode.
6
Print user codes on reports.
0: Disabled 1: Enabled
1: User codes are printed out on the Journal or
other reports.
7 Not used Do not change the settings.