Gestetner G060, Service Manual

Page: 520 / 1106

SC TABLE
G570 4-38 SM
• •
7.
SC 818 Watch-dog error While the system program is
running, other processes do
not operate at all. •
Defective controller
•
Software error
1. Turn the main switch off and on.
2. Replace the controller.
3. See NOTE 1 at the end of the SC
table.
B
SC 819 Fatal error
[696E] Process error System completely down
[766D] Memory error Unexpected system memory
size
•
Defective RAM DIMM
•
Defective ROM DIMM
•
Defective controller
•
Software error
1. Turn the main switch off and on.
2. Check and/or replace the RAM DIMM.
3. Check and/or replace the ROM
DIMM.
4. Replace the controller.
5. See
NOTE at the end of the SC
table .
B
SC820 Self-diagnostics error: CPU [XXXX]: Detailed error code
[0001]
to
[06FF] CPU error •
System firmware
problem
•
Defective controller
1. Turn the main switch off and on.
2. Reinstall the controller system
firmware.
3. Replace the controller.
When the problem cannot be fixed with
the above procedure, the following
information displayed on the screen
needs to be fed back to a technical
support center.
•
SC code
•
Detailed error code
•
Program address
B
[0702]
[0709]
[070A] CPU/Memory
Error
During the self-diagnostic,
the controller CPU detects
an error. There are 47 types
of error code (0001 to 4005)
depending on the cause of
the error. The CPU detects
an error and displays the
specific error code with the
program address where the
error occurs).
•
System firmware
problem
•
Defective RAM-DIMM
•
Defective controller
1. Turn the main switch off and on.
2. Reinstall the controller system
software.
3. Replace the RAM-DIMM.
4. Replace the controller.
B
Rev. 09/2003