Gestetner G060, Service Manual

Page: 778 / 1106

BIT SWITCHES
G307 3-54 SM
G4 Internal Switch 05
No. FUNCTION COMMENTS
0-1 Not used Do not change these settings.
2 Protocol ID check
0: Yes 1: No The Protocol ID is in the CR packet.
3-7 Not used Do not change these settings.
G4 Internal Switch 06 - Not used (do not change these settings)
G4 Internal Switch 07 - Not used (do not change these settings)
G4 Internal Switch 08 - Not used (do not change these settings)
G4 Internal Switch 09 - Not used (do not change these settings)
G4 Internal Switch 0A - Not used (do not change these settings)
G4 Internal Switch 0B - Not used (do not change these settings)
G4 Internal Switch 0C - Not used (do not change these settings)
G4 Internal Switch 0D - Not used (do not change these settings)
G4 Internal Switch 0E - Not used (do not change these settings)
G4 Internal Switch 0F - Not used (do not change these settings)
G4 Internal Switch 10 (Dch. Layer 1)
No. FUNCTION COMMENTS
0-5 Not used Do not change these settings.
6 INFO1 signal resend
0: Resend 1: No resend 0: Some DSUs may not reply to the INFO1
signal with INFO2, if there is noise in the
INFO1 signal accidentally. Try changing
this bit to 0, to resend INFO1 before the
machine displays “CHECK INTERFACE”.
7 Not used Do not change these settings.
G4 Internal Switch 11 (Dch. Layer 2)
No. FUNCTION COMMENTS
0 Not used Do not change these settings.
1 Type of TEI used
0: Dynamic TEI 1: Static TEI This is normally fixed at 0. However, some
networks may require this bit to be set at 1
(see below). In this case, you may have to
change the values of bits 2 to 7.
2
to
7
Static TEI value Store the lowest bit of the TEI at bit 7 and the
highest bit of the TEI at bit 2.
Example: If the static TEI is 011000, set bits 3
and 4 to 1 and bits 2, 5, 6, and 7 to
0.
G4 Internal Switch 12 - Not used (do not change these settings)