Gestetner G060, Service Manual

Page: 526 / 1106

SC TABLE
G570 4-44 SM
SC 999
(CF)
Program
download error
•
The download (program,
print data, language data)
from the IC card does not
execute normally.
•
BCU Board installed
incorrectly
•
Engine (BCU) board
defective
•
IC card defective
•
Incorrect IC card
used (machine
type/model, card ver.)
•
NVRAM defective
•
Incorrect destination
code
•
Defective DIMM
•
Loss of power during
downloading
NOTE 1: This error is
not logged because
the error occurs in the
download mode
(different from normal
operation mode).
NOTE 2: If the
machine loses power
while downloading, or
if the download does
not normally end for
some other reason,
this could damage the
controller board or the
target PCB of the
downloading and
prevent subsequent
downloading. If this
problem occurs, the
damaged PCB must
be replaced.
1. Turn the main switch off and on.
2. If you can download necessary
programs, do it by using an
appropriate card.
3. Check if the type and version of
firmware is correct. If correct, turn off
the main switch and reinsert the IC
card, then retry the update.
See Caution.
4. Check if the correct destination code
is set (SP5-808-1).
If it is not, please contact Technical
Support. A Regional Rep must
reprogram the destination code.
5. Check the connection of connectors
and PCBs.
6. Replace the IC card.
7. Replace the DIMM
8. Replace the BCU board.
Caution: Whenever updating the
firmware, the front cover should be
opened before turning on the main
switch.
B
Rev. 09/2003