Gestetner G060, Service Manual

Page: 888 / 1106

Copyright

 

2001 RICOH Corporation. All rights reserved.
TECHNICAL SERVICE BULLETIN TECHNICAL SERVICE BULLETIN TECHNICAL SERVICE BULLETIN TECHNICAL SERVICE BULLETIN
BULLETIN NUMBER:
BULLETIN NUMBER: BULLETIN NUMBER:
BULLETIN NUMBER: G060 - 004
G060 - 004 G060 - 004
G060 - 004 11/28/2001
11/28/2001 11/28/2001
11/28/2001
APPLICABLE MODEL
APPLICABLE MODEL APPLICABLE MODEL
APPLICABLE MODEL::::
GESTETNER – DSC38
GESTETNER – DSC38 GESTETNER – DSC38
GESTETNER – DSC38
RICOH – AP3800C
RICOH – AP3800C RICOH – AP3800C
RICOH – AP3800C
SAVIN – SLP38C
SAVIN – SLP38C SAVIN – SLP38C SAVIN – SLP38C
SUBJECT: LONG AND SHORT HAUL TRANSPORTATION PROCEDURE
Please note the following points when transporting the machine for both short and long hauls.
The printer should be returned to the original condition as when it first arrived from the factory.
Printer
1. Remove the toner cartridges to prevent toner from
flowing into the toner supply tubes due to vibrations
experienced during transport. Failure to remove the
toner cartridges could lead to toner supply tube clog.
2. Place packing material (such as shrink-wrap) into the
toner cartridge holder to shield the toner supply
entrance. This prevents toner from flowing out to the
toner cartridge holder and scattering.
3. Set the lock pin [A] (which is supplied with a new
machine) into the transfer belt unit.
4. Make sure that there is no paper left in the paper
trays and fasten the bottom plates with a sheet of
paper and tape [B].
5. Empty the waste toner bottle and attach securing
tape to prevent the bottle from becoming dislodged.
6. Attach shipping tape to the covers and doors as
shown, or shrink-wrap the machine tightly.
NOTES:
•
If pre-installing machines for some test prints at a service depot, please use a jig oil supply unit, and not
the oil supply unit enclosed with the new machine.
•
This is because the oil supply system uses a touch-and-release mechanism, which can cause the unit to
move freely up and down during transport if shipping the printer with the oil supply unit installed. This in
turn may cause damage to the white holder on the fusing unit. However, if simply moving the machine
from floor to floor, the oil supply unit can be left installed.
•
If shipping a used machine to a new location, please dispose of the used oil supply unit and install a new
one when you install the machine at the customers location because of the reason previously explained.
This is not necessary when simply moving the machine from floor to floor.
•
Whenever moving the machine to a new location, be sure to perform Auto Adjust (User Program mode)
or forced Line Position Adjustment (SP5-993-002) to optimize color line alignment.
•
Make sure that the side fences in the trays are properly positioned to prevent color shifting.
Continued…
!
GE
NE
RAL
IN
FO
R
M
A
T
IO
N
No
te:
Thi
s
c
opy i
s
i
n
tended as a m
a
st
er ori
g
inal
f
o
r reproduct
ion o
f addi
tional
bul
le
tin
s
.
[A]
[B]
CONTROL NO. 068CLR