GE Multilin W650, Instruction Manual

Page: 410 / 622

12-4 W650 Wind Generator Protection System GEK-113032A
12.1 EXAMPLE 1: COMMUNICATION & PROTECTION SETTINGS PROCEDURE 12 APPLICATION EXAMPLES
12
Under
SETPOINT
⇓
RELAY CONFIGURATION
⇒
LEDS
Under
SETPOINT
⇓
RELAY CONFIGURATION
⇒
OPERATIONS
Select
†
Operation 0
Command Text Reset C Output 00
Interlock Type None
Interlocks ---
Final State Type None
Final States ---
Frontal Key F1
Contact Input None
Virtual Output None
Time Out 500 (default)
MMI ---
Com1 ---
Com 2 ---
ETH-Master 1 ---
ETH Master 2 ---
ETH Master 3 ---
ETH Mastef 4 ---
Under
SETPOINT
⇓
RELAY CONFIGURATION
⇒
OSCILLOGRAPHY
12.1.4 TEST
Apply 7.5 A in phase A (terminals B1-B2) until contact 00 on Board F operates (terminals F19-F21 should be and remain
closed), and LED 5 should be lit. Check that operating time is in the order of 1.7 seconds.
Remove current from terminals B1-B2
Press pushbutton F1 and check that contact 00 on Board F has been open.
Check that LED 5 in the front of the relay has been turned off.
Repeat the process for phase B (terminals B3-B4) and for phase C (terminals B5-B6)
Under Actual
⇓
Waveform Capture menu retrieve the last oscillography recording stored, open it using GE_OSC program
and check that the two digital signals as well as the current signal were kept.
SELECT NAME SOURCE
†
Led 5
C Output Op 00 C Output_00_00
SELECT NAME SOURCE
†
Digital Channel 1
C Output Op_00_00 C Output Oper_00_00
†
Digital Channel 2
C Output_00_00 C Output_00_00