Fujitsu PRIMERGY TX140 S1, Upgrade And Maintenance Manual

Page: 238 / 588

238 Upgrade and Maintenance Manual
TX140 S1
Expansion cards and backup units
Ê
Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section
"Connecting the server to the mains" on
page 90 .
Ê
If applicable, close the rack door as described in section "Closing the rack
door" on page 92 .
Ê
If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
"Enabling
BitLocker functionality" on page 116 .
9.2.3 Replacing expansion cards
Note on network settings recovery
I
The following note is required for TX140 S1p (PYT14Pxxx for Japanese
market).
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
network controller or the system board.
9.2.3.1 Required tools
●
Preliminary and concluding steps: tool-less
●
Replacing expansion cards: tool-less
●
Mounting slot brackets:
– Phillips PH2 / (+) No. 2 screw driver
Upgrade and Repair Units (URU)
Average hardware task duration: 5 minutes
Average software task duration: 5 minutes