Fujitsu PRIMERGY TX140 S1, Upgrade And Maintenance Manual

Page: 361 / 588

TX140 S1
Upgrade and Maintenance Manual 361
Accessible drives
12.3.7 Concluding steps
Perform the following procedures to complete the task:
Ê
Close the front cover and reinstall the ID card as described in section
"Mounting the rack front cover" on page 77 (rack server) or "Mounting the
front cover" on page 82 (tower server).
Ê
Close the side / top cover as described in section "Mounting the top cover"
on page 80 (rack server) or "Mounting the side cover" on page 85 (tower
server).
Ê
When working on a rack-mounted server, secure it in the rack as described
in section
"Sliding the server into the rack" on page 89 .
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 87 .
Ê
Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section
"Connecting the server to the mains" on
page 90 .
Ê
If applicable, close the rack door as described in section "Closing the rack
door" on page 92 .
Ê
Verify if your backup software solution requires additional configuration after
installing, removing or replacing an accessible drive as described in section
"Verifying and configuring the backup software solution" on page 107 .
Ê
If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
"Enabling
BitLocker functionality" on page 116 .