Fujitsu PRIMERGY TX140 S1, Upgrade And Maintenance Manual

Page: 300 / 588

300 Upgrade and Maintenance Manual
TX140 S1
Main memory
10.3 Removing memory modules
10.3.1 Required tools
●
Preliminary and concluding steps: tool-less
●
Removing memory modules: tool-less
10.3.2 Preliminary steps
Before removing a memory module, perform the following steps:
Ê
Disable BitLocker functionality as described in section "Disabling BitLocker
functionality" on page 93 .
Ê
Disable boot watchdog functionality as described in section "Disabling
SVOM boot watchdog functionality" on page 94 .
Ê
If applicable, open the rack door as described in section "Opening the rack
door" on page 61 .
Ê
Locate the desired server as described in section "Locating the defective
server" on page 54 .
Ê
Shut down the defective server as described in section "Shutting down the
server" on page 61 .
Ê
Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
"Disconnecting power cords" on page 63 .
Ê
When working on a rack-mounted server, extend it out of the rack as
described in section
"Extending the server out of the rack" on page 65 .
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 66 .
Ê
Bring the server to its horizontal position.
Upgrade and Repair Units (URU)
Average task duration: 5 minutes