Fujitsu fi-8150, Operator'S Manual

Page: 121 / 434

- Type: Compliant with the ISO7810 ID-1 type
- Size: 85.6 × 53.98 mm/3.37 × 2.13 in.
- Thickness: 1.4 mm or less (Embossed cards allowed)
- Material: PVC (polyvinyl chloride) or PVCA (polyvinyl chloride acetate)
● The number of plastic cards that can be loaded in the ADF paper chute (feeder) is as follows:
- Up to 10 for non-embossed plastic cards with a thickness of 0.76 mm or less
- Up to 5 for non-embossed plastic cards with a thickness of 1.4 mm or less
Note that you can only load one card at a time if the plastic card is embossed.
●
It is recommended to place the card face-down in the ADF paper chute (feeder).
●
Rigid cards may not be fed properly.
●
If there is dirt on the surface of the card, such as grease marks (fingerprints), perform scanning after wiping
the dirt off.
● If an imprinter is connected, plastic cards cannot be scanned.
●
Notes on booklets
When you scan booklets, take note of the following.
● Make sure you use a booklet that meets the following specifications, and check if the booklet can be fed
before scanning it.
-
Thickness: 7 mm/0.28 in. or less
When you scan a passport, make sure that it also meets the following specifications.
- Type: Compliant with ISO/IEC 7810 ID-3
- Size: 125 × 88 mm/4.92 × 3.46 in. (when unopened)
- Size: 125 × 176 mm/4.92 × 6.93 in. (when opened)
● If pages are added or a VISA is attached to a passport, which results in the page thickness exceeding 7 mm, it
cannot be fed.
●
Load the open booklet face-down with the edge of the side which has more pages first in the ADF paper
chute (feeder). If you scan a booklet in the wrong orientation, the booklet may be damaged or the image
may turn out elongated vertically.
How to Load Documents
121