419-01B-17 Anti-Theft — Passive 419-01B-17
GENERAL PROCEDURES
E3809 EN 07/2001 2002 Bantam
Key Programming Using Two Programmed Keys (33 005 0)
NOTE:
This procedure only works if two or more
programmed ignition keys are available and it is
desired to program additional key(s). If two keys
are not available,
Erase All Keys and Program Two Keys in this
section
NOTE:
The Spare Key Programming Switch is a
WDS programmable switch, which provides the
capability to enable / disable the normal cus-
tomer Spare Key Programming Procedure. If the
Spare Key Programming Switch is not enabled,
then select Spare Key
Programming Switch; Enabled.
NOTE:
If the programming procedure is not
successful, the new key(s) will not start the ve-
hicle and the anti-theft indicator will flash. If the
programming procedure was not successful
leave the ignition switch in the RUN position for
at least 30 seconds, repeat the Key Program-
ming procedure from step 1. If the failure re-
peats, refer to Diagnostic and testing to review
DTCs an carry out Pinpoint Tests.
NOTE:
A maximum of eight ignition keys can be
programmed to a passive anti-theft system
(PATS) equipped vehicle.
NOTE:
If the steps are not carried out as out-
lined, the programming procedure will end.
NOTE:
Ignition keys must have correct me-
chanical key cut for the vehicle and must be a
PATS encoded key.
1. Insert the first programmed key into the
ignition lock cylinder and turn the lock
cylinder from the OFF position to the RUN
position (maintain ignition lock cylinder in
the RUN position for one second).
2. Turn ignition lock cylinder to the OFF
position and remove the first key from the
ignition lock cylinder.
3. Within five seconds of turning the ignition
lock cylinder to the OFF position, insert the
second programmed ignition key into the
ignition lock cylinder and turn the ignition
lock from the OFF position to the RUN
position (maintain the ignition lock cylinder
in the RUN position for one second).
FORD BANTAM
PAGES FROM MANUAL
