204-00-16
Suspension — General Information
204-00-16
DIAGNOSIS AND TESTING (
CONTINUED
)
E1049 EN
06/2001 2002 Bantam
CONDITIONS
DETAILS/RESULTS/ACTIONS
G5: MEASURE THE REAR WHEEL BEARING END PLAY
1
Remove the rear wheel
- Position a dial test indicator gauge with
mounting bracket to the rear brake drum.
- Push and pull the wheel hub by hand in the
axial direction and check for rear wheel
bearing endplay. There must be no endplay.
• Is the rear wheel bearing endplay within limits?
Yes
GO TO
G6
No
INSTALL a new wheel bearing as neces-
sary.
TEST the
system for normal operation.
G6: MEASURE THE WHEEL/TYRE RUN OUT ON THE VEHICLE
1
Measure the wheel and tyre run outs on the
vehicle using a radial run out gauge. Assembly
run out should be less than 1.14 mm radial and
lateral.
• Is the measurement in specification?
Yes
No
GO TO
G7
G7: MEASURE THE WHEEL/TYRE RUN OUT OFF THE VEHICLE
1
Measure the wheel and tyre from any position
that exceeds 1.14 mm radial or lateral. Before
removing the wheel, mark the wheel stud and
the corresponding stud hole so the wheel can
be installed in the same position. Remove the
wheel and mount on a wheel balancer.
Measure the run out. Wheel and tyre run out
should be less than 1.14 mm radial and lateral.
• Is the measurement in specification?
Yes
No
