501-11-16
Glass, Fram
REMOVAL AND INSTALLATION (
CONTINUED
)
es and Mechanisms
501-11-16
E6779 EN
08/2001 2002 Bantam
5. NOTE:
Discard the first 100 mm of PU
adhesive as this may have a reduced working
time.
5. NOTE:
Discard the first 100 mm of PU
adhesive as this may have a reduced working
time.
NOTE:
To avoid water leaks, any breakage in
the continuous bead should be overlapped by
20 mm.
NOTE:
To avoid water leaks, any breakage in
the continuous bead should be overlapped by
20 mm.
Apply the PU adhesive in a continuous
bead of between 8 and 10 mm height to the
rear window glass along the bond line.
Apply the PU adhesive in a continuous
bead of between 8 and 10 mm height to the
6. NOTE:
Firmly and evenly press in position;
tape the glass in the correct position until the
PU adhesive has cured.
7. Should the ambient temperature fall below
10°C, use a hot air gun at a distance of
approximately 50 mm from the surface and
apply warm air (25°C) continuously for 15
minutes (inside or outside the vehicle).
8. Install the C pillar trim cover.
FORD BANTAM
PAGES FROM MANUAL
