Fluke Biomedical medTester 5000C Operators, Operator'S Manual

Page: 166 / 292

medTester 5000C
Operators Manual
11-2
With medCheck, your medTester can interface and control external
equipment such as the Impulse 4000 Defibrillator Analyzer or the IDA 4 Plus
Infusion Pump Tester. The medTester 5000C controls these devices through
the appropriate serial cable on the medTester’s COM1 or COM2 port or
Wedge Adapter port and the RS-232 port on the Fluke Biomedical analyzer
or tester. See the section
Remote Control of Fluke Biomedical Testers at the end of
this chapter.
Note
In order to use the medCheck Module, your medTester 5000C
requires the installation of these modules:
•
RS-232/Printer Module (2)
•
100 Record Memory Module (3)
•
Expanded Memory Module (4)
•
Data Transfer Module (6)
You can find a complete list of medTester 5000C modules, their
descriptions, and requirements for use in Chapter 1,
General
Information .
What’s a Checklist?
A checklist is a list of instructions to the medTester and Technician that tells
each which tests to run and in what order. The checklist could include setup,
measurement, and wave commands (described later in this chapter). The list
could include standard and user-configured autosequences (see Chapter 5,
Autosequences ). Or it could include instructional prompts to the operator to do
something, for example, clean the Equipment Under Test (EUT) or plug the
EUT into the test receptacle.