Eurotherm 6100, User Manual

Page: 344 / 397

100/180MM DISTRIBUTED GRAPHIC RECORDER: USER GUIDE
HA029324
Issue 11 Oct 14 User Guide
Page 328
9.5.5 Serial Communications Con fi guration
Enable ‘Alarms’ in the ‘Messages To Print’ area.
Press ‘Apply’.
A sample Printout is shown in fi gure 9.5.5, in which it can be seen that it was the Orange channel which trig-
gered the warning.
Note: In the example above the event trigger is ‘Unacknowledged alarm’. This means that once the
fi rst channel alarm becomes active and the relevant report printed, then no further reports will be
initiated until the alarm is acknowledged, no matter how many other channel alarms go active. If,
however, an unlatched alarm becomes inactive, this is the equivalent of its being acknowledged as far
as report printing is concerned. For latched alarms, each alarm must be acknowledged before further
reports can be triggered.
Figure 9.5.5 Example printout