Eurotherm 6100, User Manual

Page: 269 / 397

100/180MM DISTRIBUTED GRAPHIC RECORDER: USER GUIDE
HA029324
Issue 11 Oct 14
User Guide
Page 253
Display Bargraph None If selected, a vertical bargraph is drawn at the right hand edge of Hori-
zontal Trend displays.
Display Descriptor Enable/Disable For Channel Numeric displays only, if Faceplate Style is set to ‘Custom’,
this selection determines whether or not the channel descriptor ap-
pears at the top of the display.
Display messages Enable/Disable If selected, displays a message bar for Horizontal Trend displays.
Display Pens Enable/Disable If selected, pen representations appear at the top or right edge of a
trend chart.
Display Units Enable/Disable For Channel Numeric displays only, if Faceplate Style is set to ‘Custom’,
this selection determines whether or not the channel’s units appear at
the right edge of the display.
Faceplate Style Default Produces a channel display with the descriptor and alarm indicators on
the top line and with the digital value, and units on the bottom line.
Just value Shows only the channel value
No alarms As default, but without alarm display
Value and Units Produces a larger digital display of the channel value, with units.
Single line Faceplate As default, but all on a single line.
Custom The ‘Display Descriptor’, ‘Display units’ and ‘Display Alarms’ checkbox
settings, and the font selections for Value, Units and Descriptor be-
come active only if ‘Custom’ is selected as Faceplate style.
Faceplates Location Dynamic, N, S, E, W (Not available for group horizontal bargraph displays.) Allows the posi-
tion of the faceplates to be ‘dynamic’ (appears at best position for the
number of channels), or to be located above (North), below (South),
to the right (East) or to the left (West) of the bargraphs. Also allows
faceplates to be turned off altogether. For group trend displays, these
faceplates are in addition to the current-channel faceplate, which al-
ways appears above the ‘chart’ across the full width of the display, un-
less turned off using Horizontal Faceplate disable.
Font style List of fonts Picklist holds a number of sizes, plain, bold and underlined bold.
Grid Line colour Default Allows a colour to be selected for trend chart gridlines
Horizontal Alignment Left/centred/right Allows text to be justi fi ed relative to its width setting
Horizontal Faceplate Enable/Disable For vertical trend displays, allows the current-channel faceplate to be
selected on or off.
Horizontal Grid total Default Number of vertical divisions of a trend chart. If left at default uses the
value entered in Group Con fi guration ( section 4.3.2 ). Any other setting
overrides Group Con fi guration entry.
Horizontal Minor Divs Default Allows the user to enter a number of minor grid divisions. If left at
default uses the value entered in Group Con fi guration ( section 4.3.2 ).
Any other setting overrides Group Con fi guration entry
Line thickness 1 Allows a pixel value to be entered for the line thickness of some com-
ponents. It should be noted that the nature of the screen and of the
drawing method means that curved lines of multi-pixel thickness can
suffer from Moiré fringe, or interference effects.
7.3.2 ADVANCED PARAMETERS (Cont.)
Table 7.3.2 Advanced edit level parameters (sheet 3 of 6)
Parameter Pick list content Description