Ericsson AVP 1000 1RU, Reference Manual, Page: 331 / 508

Advanced Video Processing and Networking
EN/LZT 790 0023/1 R16A
6-11
6.4.3.1 Configuring Setmode on Unit Level
By browsing to Device Configuration > Advanced Setup and selecting Base Unit ,
the Setmode can easily be configured by Offline and Online buttons and by the
Current State Parameter in the Properties widget. On the front panel, select
Advanced/System/Base Unit/Change State .
6.4.3.2 Configuring Setmode on Media Level
By browsing to Service Configuration and selecting the appropriate Transport
Stream in the Outputs widget, Setmode can easily be configured by Offline and
Online buttons and by the Status of Service parameter in the Properties widget
under the Transport Stream accordion panel. On the front panel, select
Output/Slot n/ Transport Stream ID: n/Change State .
6.5 XPO
The unit supports an HTTP interface that is XPO2 compliant for configuration and
status monitoring. At least three simultaneous HTTP sessions can be supported.
HTTP access can be enabled or disabled.
Individual parameters can be controlled via XPO2. It does not require the complete
XML configuration to be sent to change a single parameter.
Note: The legacy XPO standard is not supported.
The web pages provide a service orientated control menu structure.
6.6 User Access
6.6.1 User Authentication
The unit supports user authentication as defined in the XPO Specification. By
default, user authentication is turned off. When set to
On , a user name and
password is required to access the web pages. The default user name (engineer)
and password (password) can be changed by the user under the
Encoder > Base
Unit > User Authentication node in Device Configuration > Advanced Setup
through the web user interface or in the Advanced/System/Base Unit/User
Authentication menu through the Front Panel.