Ericsson AVP 1000 1RU, Reference Manual, Page: 115 / 508

Getting Started
EN/LZT 790 0023/1 R16A
3-73
10. Select the Component List menu in order to add one or more components to
the service.
11. Select Add Component . A new component identified by its PID appears in the
list.
12. Select the component just added (it will display none on PIDnn until a valid
component is selected.
13. Select the required Elementary Stream from the appropriate VCM and assign
an input to be handled as the component.
14. Adjust PID or Bit rate weighting if necessary.
15. Move up to the Component List menu and repeat steps 9-12 to add more
components to the service.
16. Move up to the Service List menu and repeat steps 5-13 to add more services
to the Transport Stream.
17. After the Transport Stream has been created, move up to the Transport Stream
ID: 1 menu. Select the Change State option and set it to Online .
Note: As the output has not been enabled in the Line-up menu, at this point the
unit will not produce an output through the RF connectors.
3.25.4 How to Add More Transport Streams
To add more Transport Streams to other outputs, follow the procedure detailed in
Section 3.25.3. by first selecting the Outputs menu, then repeating the Transport
Stream creation process. Alternatively, an existing Transport Stream can be copied
to another (or in case of IP output to the same) output by proceeding as follows:
1. Select Outputs .
2. Navigate to the output to which a Transport Stream is to be added.
3. Select Add Existing Transport Stream .
4. Select the Transport Stream you want to copy.
5. The selected Transport Stream will be copied to the output.
6. Select the newly copied Transport Stream.
7. Select Change State and set it to Online .
3.25.5 How to Remove a Component from a Service
To remove Components from a Service, proceed as follows:
1. Select the Output menu.
2. Select the Output containing the Transport Stream.