Ericsson AVP 1000 1RU, Reference Manual, Page: 278 / 508

Web GUI Control
5-102
EN/LZT 790 0023/1 R16A
Parameter Values Description
Field 2
VBI Line 272 - VBI
Line 285 Off, Closed Caption Specifies the content in the respective VBI lines. Set to Off
if the line in the incoming video does not carry any
information, Closed Caption for closed caption information.
Visible for 480i (525-line) input streams.
VBI Line 319 - VBI
Line 336 Off, VITC, WSS, WSS-AFD, Teletext System B Specifies the content in the respective VBI lines. Set to Off
if the line in the incoming video does not carry any
information, VITC for Time Code, WSS for Wide Screen
Signaling, WSS-AFD for Active Format Detection and
Teletext System B for Teletext.
Input Detection
The CE-x Analogue VCM supports video input detection as described in Chapter 3,
Getting Started: How to Configure and Use Input Detection .
Note: Input detection does not work for the analogue input.
5.5.3.4.2 Audio Stream Configuration
Audio Input
The following parameters are available on the Input tab of the Properties widget on the
Service Configuration page when an audio component is selected in the Outputs widget.
The same parameters can be accessed through the Advanced/CE-x Analogue/Audio
Module/Audio <n>/Input menu on the front panel.
Table 5.75 Audio Input Parameters
Parameter Values Description
Input Format Uncompressed (LPCM), MPEG Layer II, Dolby
Digital, Dolby E, AAC Sets the input format used by the audio encoder.
Input Source
Off, Mute, Test Tone, Input 1-4, Analogue 1-2,
Embedded 1 to 8 Sets the source used by the audio encoder. No input is fed
to the encoder if Off is selected. Mute mutes the incoming
audio and encodes silence. Test Tone encodes an 1 kHz
test tone. Embedded 1 to 8 are for digital input embedded
in the SDI/HD-SDI stream. Input 1-4 are for the digital
input and Analogue 1-2 are for analogue input. Analogue
and digital inputs cannot be used at the same time.
Output On Audio Loss No PID, Silence
Specifies the action to take when input is Lost. No PID is
for dropping the audio PID from the stream, Silence is for
encode silence.
NOTE: When No PID is selected, the reference to the PID
is not removed from the Program Map Table, so a
Transport Stream analyzer will indicate a ghost PID in the
output Transport Stream.
Source Switchout
Off, Mute, Test Tone, Embedded 1 to 8, Input 1 -
4 Specifies which input to output to the reference output on
the 15-way D-type audio connector.